Proximity Sensor

Product Details:

Foxtech Supreme carbon fiber propeller series are high quality propellers made for heavy duty multicotpers.All propellers are 100% well balanced,polished and reinforced, which guarantee very little deformation even with very high load.Supreme carbon fiber propeller ensures you a safe and quiet fly.

The Supreme 1550 V2 Prop is made of carbon fiber with glossy surface which core is filled with light but strong compound materials, very light, only 20g. Its excellent air dynamic design makes great improved efficiency. Perfect match with Foxtech 3520/4016 motor and T-motor U5.

Product Details:

Liquid level sensor is used to measure the level of the free-flowing substances. Such substances include water, oil, gasoline, diesel, agricultural chemicals, etc. These substances tend to get settled in the container tanks due to gravity and maintain their level in rest state. Level sensors measure their level against a pre-set reference.

Specification:

Weight: 34g
Power supply: DC 3~6V
Dimension: 24x24x21mm
Range: 30 cm water or other liquid comparable
Output: 5V 50 Hz PWM, 0%-1100us 100%-1900us
Precision: 5%
Calibration: Yes
Service Temperature: -20 ~ 40 °C

Your Purchase Includes:
1x Liquid Level Senser
1x A(yellow) hose
1x B(green) hose
1x PWM signal cable

Installation
a. We recommend to install sensor above the liquid container. A/B hoses go into the container through the top of the container.
b. A hose goes into container from top. Keep hose end above the liquid and in the container.
c. B hose goes into container from the top. Make sure its end lies on the bottom of liquid container.
Calibration
a. The green status light is on when power supplied.
b. Calibrate 0% empty level: when container is empty, press calibration button 5 seconds, status light begin to blink. 0% liquid level is calibrated.
c. Calibrate 100% full level: Fill the container full with liquid. Press calibration button 5 seconds, status light stops blinking. 100% liquid level is calibrated.
d. Calibrate again when container is changed or the sensor does not work properly.
Operation
a. Connect PWM output port to UAV flight control or Data Acquisition Module.
b. Power on. The green status light is on. The sensor works.

Product Details:

The SKYE2 integrates a high-performance ARM Cortex-M4 processor, a low-drift differential-pressure core, on-board temperature & humidity sensing, and a dual-stage temperature-compensation system. Compared with the previous generation, the new M4C smart-heating strategy—paired with a 35 W front-end heater and closed-loop thermal control—keeps the pitot tip and sensing cavity in optimal condition for cold/icing missions. A new linear, low-drag body with internal drain ports sheds water in flight, while the anti-vibration, low-drift sensor delivers stable, accurate airspeed on both electric and IC-engine UAVs. Native DroneCAN support enables plug-and-play integration with ArduPilot and other open-source stacks.

Key Features
-Aviation-grade intelligent de-icing & drainage pitot airspeed design
-High integration: pitot tube, airspeed sensor, T/H sensors, ARM Cortex-M4 MCU, dual temperature compensation
-35 W front-end heater + smart sensor thermal control for cold/icing reliability
-M4C smart-heating algorithm for targeted de-icing and automatic water shedding
-Linear low-drag profile; internal drain ports purge rainwater during flight
-Low-drift, anti-vibration differential-pressure core for demanding platforms and environments
-DroneCAN protocol; compatible with ArduPilot and other open-source autopilots
-Plug-and-play, high-accuracy airspeed output for safer flights

Your Purchase Includes:
1x SKYE2 Airspeed Sensor