Yuvvraj Global Traders
Gudadhi, Akola, Maharashtra
GST No. 27ANXPH5113M1ZH
TrustSEAL Verified
Call 08043805049 93% Response Rate
SEND EMAIL
Product Details:
| Minimum Order Quantity | 1 Piece |
| Medium | RB20 Signal Relay 902MHz-928MHz TTL Port |
The RB20 902MHz-928MHz Signal Relay is designed to enhance the long-range capabilities of a radio controller system. It consists of a ground unit and an air unit, which work together to achieve extended communication range. The ground unit can be connected to a PC using a TTL-USB cable, allowing data transmission between the PC and the RB20 air unit and enabling parameter tuning.
The RB20 signal relay is specifically designed for use with the DA16S+ radio controller. To utilize it, you need to connect the RB20 ground unit to the DA16S+ receiver and the RB20 air unit to the flight controller. By employing the RB20 signal relay, you can significantly increase the communication range. The maximum range achievable is stated to be between 15-30km, depending on the type of antenna used in conjunction with the signal relay.
For optimal performance, it is recommended to pair the RB20 signal relay with the Foxtech 840-915MHz 7dBi magnetic base antenna. When the DA16S+ radio controller is equipped with this RB20 signal relay and the specified antenna, it can achieve a maximum range of 20km.
Note: RB20 signal relay is equipped with a TTL-USB conversion cable for USB connection requirment.
Your Purchase Includes:
1x RB20 Ground Unit
1x RB20 Air Unit
2x Antennas
1x Power Cable
The defult values of RB20:
NETID: 65535 BAUDRATE: 115200 CHANEEL: 1 POWER: 1W
If want to modify the parameters, please do as following procedure:
1.Connect RB20 to PC through TTL-USB cable, then press and hold the setting button and power on the RB20 at the same time.
2.Wait for the drive to read the corresponding port, and click"Connect" , then begin to modify the parameters.
3. After the parameter setting, click "Write" to save the changes and exit.
Product Details:
| Minimum Order Quantity | 1 Piece |
| Voltage Type | DC |
| Voltage | 5 V |
| Current | 30 A |
This power relay is controlled by PWM(+5V -) signal to realize high level(1) and low level(0) trigger and used as a power switch, so it can be used for mapping camera to triger and also could control other equipments like lamp on your drone.
Your Purchase Includes:
1x PWM Signal Control Power Relay